線徑：Wire diameter （d）
外徑：Outside of diameter (O.D)
內徑: Inside of diameter (I.D)
中心徑: Mean coil diameter (C.D)
有效圈數: Active coil Number (Na)
總圈數: Total number of coils (Nt)
自由長度: Free length (F.L)
自由高度: Free height (F.H)
卷方向: Winding
右旋: Right hand screw
左旋: Left hand screw
材質: Material
一般鋼線: SWC
琴鋼線: SWP-B (For press force)
SWP-A (For pull force)
不銹鋼線: Stainless steel
閉端研磨: Closed and ground
表面處理: Surface treatment
低溫熱處理: Low temperature heat treatment
安全荷重: Total safe load
壓時之荷重: Load at pressing length
防銹油: Preventing rust oil
電鍍: Electroplating
電解: Electrolytic
鍍洛: Chroming
鍍鋅: Zinc-plating
五彩鍍鋅: Colored-plating
染黑: Black-dyeing
烤漆: Paint drying
鈍化: Passiveness
永久變形: Permanent set
斜率: Rate (R)
移除: Remove
立定處理: Setting
應力消除: Stress relieve
彈簧剛度產生單位變形量的彈簧負荷: Spring constant
強壓（拉、扭）處理: Crush (pull, twist) processing
開口不磨平: Open ends, not ground
沖擊試驗: Impact test
負荷: Load (P)
環: Loops
模量: Modulus
開口磨平: Open ends ground
鋁板: Aluminum plate
更多資訊，敬請掃描以下二維碼，完成關注，Thanks 么么噠！
